MIL-L-48063 Launcher, Rocket, Lau 68B/A Shipping AssemblyThis specification covers the technical requirements, quality assurance and reliability provisions and special requirements not covered by the drawings for the parts and assembly of an external store type rocket launcher for shipping, storing, and launching 2.75 Inch Folding Fin Aircraft Rockets \(FFAR\).

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17

MIL-L-48063A(MI)

4.3.2 Examination. The examinations listed in the following

subparagraphs shall be performed on inspection lots (see 4.3.1) of the

components or assemblies designated in the applicable paragraph headings.

Inspection for critical defects (and major defects, when so specified)

shall be 100 percent. Sampling plans for major and minor defects shall

be in accordance with MIL-STD-105 except that continuous sampling plans

in accordance with MIL-STD-1235 may be used if approved by the Government.

Instead of applying the AQL's designated herein to the groups of major

and minor defects listed, the contractor may elect to apply AQL's to

individual defects using an AQL of 0.40 percent for each major defect

and an AQL of 0.65 percent for each minor defect. When this method

is elected, it shall be applied to all of the major and minor defects

listed in the applicable subparagraph of this section, except where 100

percent inspection is specified, and be documented as part of the

contractor's inspection system. Equipment necessary for the

performance of the inspections listed shall be in accordance with 4.3.4.

4.3.2.1 Tube, Launcher (see dwg. 356AS144 covering a detail of dwg.

356AS100).

Defects

Method of Inspection