MIL-L-48063A(MI)
(5) Two (2) in accordance with Vibration, (4.4.9.9) and Static Firing,
(4.4.9.10).
(6) Two (2) in accordance with Flight Firing, (4.4.9.11).
d. Five (5) sets of subassemblies in accordance with applicable
drawings.
Five (5) sets of component parts in accordance with applicable
drawings.
4.2.3 Rejection. If any assembly or component fails to comply with
any of the requirements and inspections, the First Article sample shall be
rejected. The Government reserves the right to terminate its inspection
upon any failure of any assembly or component in the sample to comply with
any of the stated requirements. In the event of rejection, the Government
reserves the right to require the contractor to take corrective action and/or
submit a new First Article sample of double sample size or portion thereof.
Until a First Article sample is accepted, the contractor is, in no way,
authorized by the Government to initiate regular production unless directed
by the Contracting Officer.
4.3 Inspection provisions.
4.3.1 Lot formation. The term "inspection lot" as used in this
specification is defined as an essentially homogeneous collection of units
of product from which a representative sample is drawn and inspected to
determine conformance with applicable requirements. The sample selected
shall represent only that quantity of units from which the sample was drawn
and shall not be construed to represent any prior or subsequent quantities
presented for inspection. Homogeneity shall be considered to exist provided
the inspection lot has been produced by one manufacturer, in one unchanged
process, using the same materials and method, in accordance with the same
drawing, same drawing revision, same specification and same specification
revision and complies with the provisions for submission of product as
specified in MIL-STD-105. Changes to the process, specification or
drawing not affecting safety, performance, interchangeability, or storage,
as determined by the Government, shall not be deemed to alter the
homogeneity of an inspection lot. All material submitted for inspection
in accordance with this specification shall comply with the homogeneity
criteria specified herein regardless of the type of sampling procedure which
is being applied to determine conformance with requirements. A sample con-
taining known defects will not be submitted unless specifically authorized
by the Contracting Officer. Lot numbering, as required, shall be in accordance
with MIL-STD-1168 Each inspection lot shall bear a unique lot number.
11
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business