MIL-T-60916C(MI)
Drawing and specification number and date, together with
b.
identification and date of changes thereto.
A statement that all material purchased by the contractor meets
c.
requirements, when such material is controlled by Government or commercial
specifications referenced in any of the contractual documents, and that
certificates of conformance are on file and available for review.
Number of items in the lot.
d.
e.
Date submitted.
The certificates shall be signed by a responsible agent of the certifying
The initial certificate submitted shall be substantiated by
organization.
Substantiation of
evidence of the agent's authority to bind his principal.
the agents authority will not be required with subsequent certificates unless,
during the course of the contract, this authority is vested in another agent
of the certifying organization.
4.6.2 Lot formation.
In this specification the term inspection lot is
an essentially homogeneous collection of units of products from which a
representative sample is drawn and inspected to determine conformance with
applicable requirements. The sample selected shall represent only that
quantity of units from which the sample was drawn and shall not be construed
to represent any prior or subsequent quantities presented for inspection.
Homogeneity shall be considered to exist provided the inspection lot has been
produced by one manufacturer, in one unchanged process, in accordance with the
same drawing, same drawing revision, same specification and same specification
revision.
Changes to the process, specification or drawing not affecting
safety, performance, interchangeability, or storage as determined by the
Government, shall not be deemed to alter the homogeneity of the inspection
lot .
All material submitted for inspection in accordance with this
specification shall comply with the homogeneity criteria specified herein
regardless of the type of sampling procedure which is being applied to
determine conformance with requirements.
Lot numbering as required, shall be
in accordance with MIL-STD-1168.
Each inspection lot shall bear a unique lot
number. Unless otherwise approved by the contracting officer, the inspection
lot size of end items deliverable under the contract shall be not less than
10,000 nor greater than 50,000 units.
4.6.3 Examination. The examinations specified herein shall be
performed on inspection lots (see 4.6.2) of the components or assemblies in
the applicable paragraph headings.
Sampling plans shall be in accordance with
Tables II, III and IV of this specification.
6
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business